Pipe

I collected my tilt switches earlier today from the Electronics School and have just got back from a tour of the DIY stores looking for a pipe wide enough for my circuit board to fit in. I ended up getting a downpipe normally used with guttering. I got some funny looks from the shop staff in most of them as I tried to squeeze the circuit board into the pipe to see if it would fit. Probably thought I was a terrorist. Time to get the saw out and start hacking it up – just as well they had loads left!!

Guttering before being turned into a rain stick

End of the pipe


One Comment on “Pipe”

  1. Good stuff, look forward to hearing the results 🙂


Leave a Reply

Your email address will not be published. Required fields are marked *